Zwift Ride – Rocker Front Feet Installation guide

Rocker Front Feet for Zwift Ride. Screw the feet into place, then insert the tennis balls.

Difficulty
Easy

View product

Rocker Front Feet for the Zwift Ride – detail – StudioVelo3D

Before you start.

Check that both Rocker Front Feet are undamaged. Support the bike during fitting.

These feet are screwed into place and do not slide over the rubber feet. Confirm the correct fixing arrangement before installation. Two tennis balls are required and are not included.

[ WHAT IS IN THE BOX ]

  • 2 x Rocker Front Feet
  • Tennis balls are not included - any two standard tennis balls work
[ WARNING ]

PLACEHOLDER. Confirm how the front of the bike should be supported while the standard feet are off, and the maximum rider weight.

Follow the steps.

  1. [ 01 / 04 ]

    Prepare the front mounting points

    Support the Zwift Ride securely before working at the front mounting points. Check the screw attachment arrangement; these feet do not slide over the rubber feet.

    [ NOTE ]

    Use the screw attachment intended for the Zwift Ride front feet.

  2. [ 02 / 04 ]

    Screw the Rocker Front Feet into place

    Screw both Rocker Front Feet into place at the front mounting points. Check that both feet are securely attached before inserting the tennis balls.

  3. [ 03 / 04 ]

    Add the tennis balls

    The movement comes from two standard tennis balls that sit in the feet. Tennis balls are not included, and any two standard tennis balls work.

    PLACEHOLDER CONTENT. Place one ball in each foot and check both sit the same way.

  4. [ 04 / 04 ]

    Check the movement

    PLACEHOLDER CONTENT. Rock the front of the bike gently by hand. It should move fore and aft and return to centre, with the rear staying planted.

    [ WARNING ]

    PLACEHOLDER. Add the confirmed maximum rider weight, and anything to check before the first ride.

Final check.

Complete every check before using the product.

Using your product.

PLACEHOLDER CONTENT. Ride as normal. The front of the bike now moves fore and aft instead of staying locked in place.

Care and adjustments.

PLACEHOLDER CONTENT. Wipe the feet with a damp cloth. Sweat is corrosive, so clean them after hard sessions.

Tennis balls are a wear part. Replace them when they stop rebounding.

Questions about this product.

Are tennis balls included?

No. Tennis balls are not included, and any two standard tennis balls work.

Why tennis balls?

Tennis balls compress and rebound progressively, which makes them quiet, durable and easy to replace. It is the same principle a rocker plate uses, at a fraction of the cost and footprint.

Is there a maximum rider weight?

PLACEHOLDER ANSWER. Confirm the maximum rider weight before this guide goes live.

Need help?

Send a photo of your setup and tell us where you get stuck.

Contact StudioVelo3D