Build your Bar or Rack

Choose a Bar or Rack, fill every position and arrange your cycling gear.

One complete setup. One fixed bundle price. Choose your holders to see the value of your setup.

[ 01 ]

Choose Bar or Rack

[ 02 ]

Choose your length

Choose Bar or Rack first.

Central wall connection Pre-assembled rod connection, wall-side mount, two 5 × 40 mm screws, two M5 washers and two 8 × 40 mm plugs.
Included
Holder colour Black
[ 03 ]

Choose your holders

Capacity used 0 / 0

Every length includes a fixed number of holders. Fill every position.

Choose Bar or Rack and a length to add holders.

[ 04 ]

Your complete setup

Your complete setup is added as one bundle.
[ 05 ]

What's included

Your complete setup includes the selected rod length, all selected holders and the mounting materials below.

  • Rod assembly with pre-mounted connector and two small screws
  • Wall-side mounting part, two 5 × 40 mm screws, two M5 washers and two 8 × 40 mm plugs
  • All selected holders. Each Bar shoe-hook set contains two hooks; the Rack shoe holder includes its base and two hooks.
  • One 3.5 × 16 mm rear fixing screw per Bar tray, if selected
[ 06 ]

Mounts in minutes

Fix the wall-side mount, seat the pre-assembled rod connection, then slide on the holders from the free rod ends.

[ 01 ]Mark and prepare the two wall fixing points
[ 02 ]Secure the wall-side mount and seat the rod assembly
[ 03 ]Slide on the selected holders; fit tray screws and shoe hooks where included

Use wall plugs suitable for your wall. Keep the pre-fitted rod screws in place. Follow the installation guide for the assembly sequence.

View installation guide →
[ 07 ]

FAQ

What is the difference between a Bar and a Rack?

A Bar is horizontal: holders sit side by side and give a wide overview of your gear. A Rack is vertical: holders stack from top to bottom and use less wall width.

Which length should I choose?

Bar 400 mm holds exactly 2 holders; Bar 600 mm holds 4. Rack 400 mm holds 4 holders and Rack 600 mm holds 5. A Bar shoe-hook pair counts as one holder set.

Can I use the same holders on a Bar and a Rack?

Choose holders made for your Bar or Rack. Rack: maximum one helmet holder at the top and one shoe holder at the bottom. Bar: any order, with repeat holders allowed up to the full holder count for its length.

Can I change or add holders later?

Yes. The holders are modular. Every new Bar or Rack is supplied with the full number of holders for its length. Separate replacement and expansion parts are planned for later.

Is mounting hardware included?

Yes. Your Bar or Rack includes the pre-assembled rod connection, wall-side mount, two wall screws, washers and plugs. Bar trays include their rear fixing screw; Rack shoe holders include two separate hooks.