Wahoo Kickr Core 2 – Rocker Feet Installation guide

Rocker feet for the Wahoo Kickr Core 2. They slot on without tools or modification. Tennis balls are not included.

Install
Trainer mounted

View product

Rocker Feet for the Wahoo Kickr Core 2 indoor trainer – StudioVelo3D

Before you start.

Keep the original rubber feet in place. Slide the Rocker Feet over the trainer legs and rubber feet, then fit the two tennis balls.

PLACEHOLDER CONTENT. Read this fully before you fit the feet.

  • Two Rocker Feet are in the box.
  • You need two standard tennis balls. They are not included.
  • Take the bike off the trainer before you start.
  • Put the trainer on a level floor with room to move.

[ WHAT IS IN THE BOX ]

  • 2 x Rocker Feet
  • Tennis balls are not included - any two standard tennis balls work
[ WARNING ]

PLACEHOLDER. Confirm the maximum rider weight and anything to check before the first ride.

Follow the steps.

  1. [ 01 / 04 ]

    Clear the trainer

    PLACEHOLDER CONTENT. Take the bike off the Kickr Core 2 and put the trainer on a flat, level floor with room to move.

  2. [ 02 / 04 ]

    Slide the Rocker Feet over the rubber feet

    Leave the original rubber feet on the trainer. Slide the Rocker Feet over the legs and existing rubber, then check that both are fully seated before adding the tennis balls.

  3. [ 03 / 04 ]

    Add the tennis balls

    The rocking motion comes from two standard tennis balls that sit in the feet. Tennis balls are not included, and any two standard tennis balls work.

    PLACEHOLDER CONTENT. Place one ball in each foot and check both sit the same way.

  4. [ 04 / 04 ]

    Check the movement

    PLACEHOLDER CONTENT. Put the bike back on the trainer and rock it gently by hand. It should move fore and aft and return to centre.

    [ WARNING ]

    PLACEHOLDER. Add the confirmed maximum rider weight, and anything to check before the first ride.

Final check.

Complete every check before using the product.

Using your product.

PLACEHOLDER CONTENT. Ride as normal. The trainer now moves fore and aft instead of staying locked in place.

Care and adjustments.

PLACEHOLDER CONTENT. Wipe the feet with a damp cloth. Sweat is corrosive, so clean them after hard sessions.

Tennis balls are a wear part. Replace them when they stop rebounding.

Questions about this product.

Are tennis balls included?

No. Tennis balls are not included, and any two standard tennis balls work.

Does it fit other Kickr models?

These are made for the Wahoo Kickr Core 2 specifically, not adapted from a universal version, and they slot on without modification.

PLACEHOLDER. Confirm which other trainers, if any, they fit.

Do I need tools?

No tools are required. The feet slot onto the trainer without modification.

Need help?

Send a photo of your setup and tell us where you get stuck.

Contact StudioVelo3D